Application area:
· Cove lighting
· Architectural lights for canopy, archway
· Backlight or edge lighting for signage
· DIY lights for home use
· Path and contour marking
· Decorative lights for holiday, event, show, exhibition, hotel
Using Notice:
· The LED RGB strip light itself and all its components may not be mechanically stressed.
· Assembly must not damage or destroy conducting paths on the circuit board.
· Installation of LED ribbon (with power supplies) needs to be made with regard to all applicable electrical and safety standards. Only qualified personnel should be allowed to perform installations.
· Correct electrical polarity needs to be observed. Wrong polarity may destroy the strip.
· Parallel connection is highly recommended as safe electrical operation mode.
· Serial connection is not recommended. Unbalanced voltage drop can cause hazardous overload and damage the strip.
· Please ensure that the power supply is of adapters power to operate the total load.
· When mounting on metallic or otherwise conductive surfaces, there needs to be an electrical isolation points between strip and the mounting surface.
· Pay attention to standard ESD precautions when installing the strip.
· Damaged by corrosion will not be honored as a materials defect claim. It is the user’s responsibility to provide suitable protection against corrosive agents such as moisture and condensation and other harmful elements.
· Caution needs to be taken while doing the connection after cutting the strip. Only authorized professionals can do the work to enable it waterproof in wet locations.
Typical Connectting Diagram
